GSO ASTM G52:2024
Gulf Standard
Current Edition
·
Approved on
25 April 2024
·
Standard Practice for Exposing and Evaluating Metals and Alloys in Surface Seawater
GSO ASTM G52:2024 Files
No files are available for this standard right now!
GSO ASTM G52:2024 Scope
1.1 This practice covers conditions for the exposure of
metals, alloys, and other materials in natural surface seawater
such as those typically found in bays, harbors, channels, and so
forth,2 as contrasted with deep ocean testing.3 This practice
covers full immersion, tidal zone and related splash, and spray
zone exposures.2,4
1.2 This practice sets forth general procedures that should
be followed in conducting seawater exposure tests so that
meaningful comparisons may be made from one location to
another.
1.3 This practice identifies recommended procedures for
evaluating the effects of natural surface seawater on the
materials exposed.
1.4 The values stated in SI units are to be regarded as
standard. The values given in parentheses after SI units are
provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the
safety concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO ASTM D4778:2024
ASTM D4778:15
Gulf Standard
Standard Test Method for Determination of Corrosion and Fouling Tendency of Cooling Water Under Heat Transfer Conditions (Withdrawn 2024)
GSO ISO 11114-6:2024
ISO 11114-6:2022
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 6: Oxygen pressure surge testing
GSO ISO 23598:2024
ISO 23598:2021
Gulf Standard
Mechanical joining of sheet materials — Destructive testing of joints — Specimen dimensions and procedure for mechanized peel testing of single joints
GSO ISO 22407:2024
ISO 22407:2021
Gulf Standard
Metallic materials — Fatigue testing — Axial plane bending method